Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual

ADJUSTMENT (Model R200)

ADJUSTMENT (Model R200)

Pinion Gear Height and Pinion Bearing Preload

(Cont'd)

7. Place the J-34309-11 “R200A” pinion height adapter onto the gauge plate and tighten it by hand.

CAUTION: Make sure all machined surfaces are clean.

— PINION BEARING PRELOAD WASHER SELECTION —

8. Place the solid pinion bearing spacer, small end first, over the J-34309-2 gauge anvil and seat the small end squarely against the tip of the J-34309-1 gauge screw in the tool recessed portion.

an AN Ya

SPD773

9. Select the correct thickness of pinion bearing preload adjusting washer using a standard gauge of 3.5 mm (0.138 in) and your J-34309-101 feeler gauge. The exact measure you get with your gauges is the thickness of the adjust- ing washer required. Select the correct washer from the following chart. Drive pinion bearing preload adjusting washer: Refer to S.D.S.

10. Set your selected, correct pinion bearing preload adjusting washer aside for use when assembling the pinion gear and bearings into the final drive.

SPD774

PD-21

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.