Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

C=) I aco: \, 4) == ee - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › C=) I aco: \, 4) == ee - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXC=) I aco: \, 4) == ee - Nissan 240SX 1991-1992 Workshop Manual

C=) I aco: \, 4) == ee

SUPER HICAS SYSTEM — Repair of Component Parts Power Cylinder (Cont'd) While attaching a wrench to ‘‘width across flats’’ section of rod end from which stroke stopper was removed, remove the other lower link assembly.

SST716B ASSEMBLY Install stroke stopper and lock nut on the lower link assem-

1. bly to be assembled.

SST388B Apply Locktite to inner ball joint thread. Attach a wrench to “width across flats’’ section of piston rod (located on the other side) to prevent rod from turning. Install lower link assembly.

$ST717B After installing stroke stopper and lock nut on the other lower link assembly, install lower link assembly. Attach a wrench to inner ball joint (to prevent it from turning), tighten inner socket to specified torque.

C=) I aco: \, 4) == ee

Inner socket: (): 78 - 98 N-m (8 - 10 kg-m, 58 - 72 ft-lb)

S$ST718B lf stroke stopper was moved during removal of lower link, Lock nut (0) 49-69 Nm adjust it after installation, as described below: (5.0 - 7.0 kg-m, 36 - 51 ft-Ib) Loosen lock nut which secures stroke stopper. Turn stroke stopper until clearance between inner ball joint 3 mm (0.12 in) and stroke stopper is 3 mm (0.12 in) on each side. Tighten lock nut securely. Lock nut: (): 49 - 69 N-m (5.0 - 7.0 kg-m, 36 - 51 ft-lb) Recheck clearance between inner ball joint and stroke stopper on each side. SST391B ST-38

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.