TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Electrical Components Inspection (Cont'd)
THROTTLE VALVE SWITCH (idle position) (A/T model only)
1. Warm up engine sufficiently. at
2. Disconnect throttle valve switch harness connector.
3. Check continuity between terminals @ and ©.
| Accelerator pedal condition | Continuity |
|---|---|
| Released | Yes |
| Depressed | No |
SEF186M If N.G., replace throttle valve switch.
Adjustment for throttle valve switch (A/T model only) If throttle sensor or throttle valve switch is replaced or removed, it is necessary to install it in the proper position, by following the procedure as shown below:
1. Install throttle sensor body in throttle chamber. Do not tighten bolts. Connect throttle sensor and idle switch harness connector. Start engine and warm it up sufficiently. Disconnect idle switch harness connector. Check idle switch OFF —> ON speed with circuit tester, clos- akon ing throttle valve manually. idle switch OFF — ON speed: A/T: Engine speed in “N’’ position 900+ 150 rpm
A.A.C. VALVE
Check A.A.C. valve resistance. Resistance: Approximately 100
SEF352I EF & EC-167
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.