Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 9 0/0

SYMPTOM: A/T does not shift from D; to D. at the

O or Self-diegnosis specified speed. .

start “3

A/T does not shift from D. to D2 when

lagnosi depressing accelerator pedal fully at the Po Light specified speed. Are Diagnostic Procedures 7 and | No | Goto Diagnostic Procedure 7 or SAT157C Yes y Yes > Check inhibitor switch circuit. Does “E.C.U. INPUT speedometer to inhibitor switch circuit? Revolution Speed sensor TT OR 1 Does self-diagnosis show damage to inhibitor switch circuit? +35 27

25. A/T control unit SAT980D No y N.G. | Repair or replace revolution Check revolution sensor and Throttle sensor and 7 | | — 3 | "| sensor and speed sensor circuits. speed sensor circuit. — Refer to wf Z throttle valve switch “’Self-diagnosis’’. / y O.K. * N.G ; Check throttle sensor. — Refer —+| Repair or replace throttle sensor. to section EF & EC. \x O.K. 4 i N.G. _

1. Remove oil pan.

fA

"| | 1. Remove control valve. —

SAT7390 } | 2. Check A/T fluid condition.

—— 7 Refer to ““ON-VEHICLE SERVICE”. O.K. "|

2. Check the following items. @ Shift valve A O.K. @ Shift solenoid A @ Pilot valve ‘ O-K. || © Pilot filter

3. Disassemble A/T.

4. Check the following items. @ Servo piston assembly @ Brake band SATI718 @ Oil pump assembly 8/8 v |s/s Di-+D2 NG / . .

1. Perform A/T control unit Depress Check again. »| flv input/output signal inspection.

2. If N.G., recheck A/T control

; O.K. @ 'D:) unit pin terminals for damage D “Dd or connection of A/T control 27 j

“+ Release

INSPECTION END

0/8 x» ors | unit harness connector. SAT118B © AT-62

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.