Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DIAGNOSES — Overall System - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DIAGNOSES — Overall System - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDIAGNOSES — Overall System - Nissan 240SX 1991-1992 Workshop Manual

DIAGNOSES — Overall System

DIAGNOSES — Overall System

Sight Glass Inspection for System

As previously stated, the inspection characteristics of the sight glass on a system equipped with the V-5 compressor are different from a system using a fixed displacement compressor. Refer to the information below: Inspection conditions > Operate the engine at approximately 1,500 rpm. Open the door windows. Set the fan switch to the ‘‘MAX”’ position. Turn the air conditioner switch ‘‘ON”’. Ensure that compressor discharge pressure is at least 588 kPa (6 kg/cm’, 85 psi). aOPoONn When discharge pressure does not reach 588 kPa (6 kg/cm’, 85 psi) in areas where outside air temperature is low, proceed as follows: e Set the TEMP. LEVER to the ‘‘full-hot’’ position. Set the intake lever/switch to the recirculation position. e e Close the door windows completely. e Increase the compartment temperature so that discharge pressure reaches at least 588 kPa (6

kg/cm?, 85 psi).

Refrigerant charge amount checking Check the refrigerant charge amount using the following table as a guide.

Item to checkAdequateInsufficientAlmost no refrigerantToo much refrigerant
State in sight glassCLEARFOAMY or BUBBLYFROSTYNO FOAM
Air bubbles sometimesAir bubbles always appear.Frost appears.No air bubbles appear.
appear when engine speed
is increased or decreased.
Temperature ofHigh-pressure side is hotHigh-pressure side is warmThere is almost noHigh-pressure is hot and
high and lowwhile low-pressure side isand low-pressure side istemperature differencelow-pressure side is slightly warm. (Slight
pressure linescold. (A big temperatureslightly cold. (Not so largebetween high and low-slightly warm. (Slight
difference between high anda temperature differencepressure side.temperature difference
and low-pressure side.)between high and low-between high and low- pressure side.)
pressure side.)pressure side.)
Pressure of systemBoth pressures on high andBoth pressures on high andHigh-pressure side isBoth pressure on high and
low-pressure sides arelow-pressure sides areabnormally low.low-pressure sides are
normal.slightly low.abnormally high.

RHA264B

HA-59

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.