Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 37 (Cont'd)

INSPECTION START

y OK.

INSPECTION END

CHECK OVERALL FUNCTION.

1) Start engine and warm it up suffi- ciently. 2) Run engine at about 2,000 rpm for about 2 minutes under no-load. 3) Release accelerator pedal fully, and run engine at idle. 4) Listen to A.I.V. operating sound. At idle and during deceleration: A.I.V. should operate. Except above: A.I.V. should not operate. N.G. BI Vv O.K.

»| CHECK COMPONENT

CHECK VACUUM SOURCE TO A.L.V.

“| (ALY). 1) Disconnect vacuum hose to A.1.V. Refer to “Electrical Com- 2) Make sure that vacuum exists under ponents Inspection’’. the following conditions. MEF705 A (See page EF & EC-170.) At idle and during deceleration: Vacuum should exist. Except above: CONNECT

((_c7unir fe} connecToR J

Vacuum should not exist. € 102 N.G. ¥ O.K.

CHECK VACUUM HOSE.

CHECK CONTROL FUNCTION.

v 1) Check voltage between E.C.U. termi- Check vacuum hose for nal@oDand ground. clogging, cracks and proper connections. Voltage: At idle and during SEF9631 deceleration Approximately 0V Except above Battery voltage N.G. y N.G. Check the following.

CHECK POWER SUPPLY.

e 10A fuse 1) Stop engine. 2) Disconnect A.!.V. control solenoid e Harness continuity

—~ between fuse and A.I.V. valve harness connector. 3) Turn ignition switch ‘“‘ON”’. control solenoid valve

AN Improper connection

4) Check voltage between terminal ©

SEF816F If N.G., repair harness or connectors. and ground. Voltage: Battery voltage O.K. Vv @

MEF706A

EF & EC-134

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.