Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

A/T Shift Lock System (Cont'd)

DIAGNOSTIC PROCEDURE 2

1 | SYMPTOM: : = a4

Ignition key cannot be removed when selector lever is set to “P”

€> HS. position or can be removed when selector lever is set to any position except “P”’. | aw |

Check the following items:

|-S-] ® 7

CHECK Power source.

1. Harness continuity between

- . Control unit

1. terminal

battery and control unit

(tr)

harness terminal (@)

SAT991D

2. Fuse

2. Check voltage between con-

trol unit harness terminal j CONNECT [i85 (4 and ground.

Battery voltages should exist.

€ > H.S O.K. fe) Oe G/L =

N.G. | Check the following items:

CHECK IGNITION SIGNAL.

Control unit

1. Harness continuity between

1. terminal (tr) battery and control unit harness terminal ©) SAT992D

2. Fuse

3. Ignition switch

2. Check voltage between con- USCOWNEET Co trol unit harness terminal 6) €:) 4

and ground.

OV oO

3. (Gs OF WY K 8

Control unit

terminal [Q]

4. Check voltage between con- - trol unit harness terminal @) and ground. Battery voltage should exist. SAT993D : ° . . N.G.

CHECK GROUND CIRCUIT

Repair harness or connector.

FOR CONTROL UNIT.

1. (Ge,

2. Disconnect control unit harness connector.

3. Check continuity between control unit harness terminal () and ground. Continuity should exist. O.K.

AT-89

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.