Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

SHIFT SOLENOID A CIRCUIT CHECK

Shift solenoid A TOO N.G.

1. Remove control valve assem-

CHECK GROUND CIRCUIT.

-— Terminal bly. — Refer to “‘ON-VEHI- il-_————— cord

CLE SERVICE”.

assembly . Check the following items. NO @ Shift solenoid A — Refer to

2. Disconnect terminal cord 6 “Electrical Components assembly connector in engine A/T control unit Inspection’. compartment. @ Harness continuity of terminal

3. Check resistance between SAT968B cord assembly

terminal ©) and ground.

A dQ: Resistance: 20 - 3022 Solenoids harness connector O.K. 3) ‘ e @® N.G.

CHECK POWER SOURCE

Repair or replace harness

“| between A/T control unit and

CIRCUIT. terminal cord assembly. -

2. Disconnect A/T control unit = SAT968D connector.

3. Check resistance between |B

FED tame

terminal ©) and A/T control

harness 4 5.

unit terminal ©).

Gs) Resistance: DISCONNECT &) Approximately 022

4. Reinstall any part removed. O.K. y N.G. Perform self-diagnosis after

1. Perform A/T control unit driving for a while. input/output signal inspection.

2. If N.G., recheck A/T control O.K. unit pin terminals for damage v or connection of A/T control

INSPECTION END

unit harness connector. DISCONNECT e C/UNIT

|°| CONNECTOR

6

SAT969D

AT-43

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.