Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual

ON-VEHICLE SERVICE

ON-VEHICLE SERVICE

Checking Steering Wheel Play With wheels in a straight-ahead position, check steering wheel

1. play. Steering wheel play: 35 mm (1.38 in) or less If it is not within specification, check steering gear assembly when front suspension and axle, steering gear assembly and steering column are mounted correctly.

SST103B Checking Neutral Position on Steering Wheel Pre-checking N.G. O.K. Make sure that wheel alignment is correct. @ Wheel alignment:

Refer to section FA for S.D.S.

/

@ Verify that the steering gear is centered before removing the

eS) \ steering wheel. Checking Ww S

@ Check that the steering wheel is in the neutral position when

— driving straight ahead. If it is not in the neutral position, remove the steering wheel SST104B e and reinstall it correctly. If the neutral position is between two serrated teeth, loosen @ tie-rod lock nut and move tie-rod in the opposite direction by the same amount on both left and right sides to compensate for error in the neutral position.

Front Wheel Turning Angle Rotate steering wheel all the way right and left; measure turning angle. Turning angle of full turns: Refer to section FA for S.D.S.

If it is not within specification, check rack stroke. Measured length “L”: Refer to S.D.S.

SSTO86B ST-4

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.