CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER BLOCK
CYLINDER BLOCK
Assembly (Cont'd) Heat piston to 60 to 70°C (140 to 158°F) and assemble piston,
2. Front mark Piston grade number piston pin, connecting rod and new snap ring. e Align the direction of piston and connecting rod. e@ Numbers stamped on connecting rod and cap correspond to each cylinder. e After assembly, make sure connecting rod swings smoothly.
Cylinder number \ cy SEM311D
3. Set piston rings as shown. Punchmark side up
CAUTION: (if mark is present.) e When piston rings are not being replaced, make sure that ae piston rings are mounted in their original positions. e When piston rings are being replaced and no punchmark is present, piston rings can be mounted with either side up.
SEM264C @ Top ring Oil ring expander
Y 2 Oil ring
ya ‘i upper rail
2nd .
| Sane rail
. ring SEM160B CRANKSHAFT
1. Set main bearings in their proper positions on cylinder block and main bearing beam. e Confirm that correct main bearings are used. Refer to ‘“‘Inspection”’ of this section.
SEM448C
2. Install crankshaft and main bearing beam and tighten bolts to the specified torque. e Prior to tightening bearing cap bolts, place bearing cap in its proper position by shifting crankshaft in the axial direc- tion. e Tighten bearing cap bolts gradually in two or three stages. Start with center bearing and move outward sequentially. e After securing bearing cap bolts, make sure crankshaft turns smoothly by hand.
EM-46
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.