Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Service Tools (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Service Tools (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXService Tools (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Service Tools (Cont'd)

PREPARATION

Service Tools (Cont'd)

TypeDetection abilityFeatures
e Low price
Halide torch200 g (7.05 oz)/year (thin green)e Low sensitivity e Less safe because of the use of
Halide torch200 g (7.05 oz)/year (thin green)e Less safe because of the use of
flame for detection
e Easy handling
Discharge type (Suction type)- .11- 1.7 / 3- 50g (0 6 oz)/yeare Medium sensitivity e Each point needs tow or more sec-
Electricalonds for detection. e@ High sensitivity
Positive ione@ High sensitivity e High price
Positive ion emission type2 g (0.07 oz)/yeare High price e Warm-up time is needed because a
emission type (Suction type)2 g (0.07 oz)/yeare Warm-up time is needed because a heater is incorporated.
Other simple checking method: Change in vacuum when evacuating1 kg (2 Ib)/month; if 13.3 kPa (100 mmHg, 3.94 inHg) change in vac- uum is detected in 10 minutes.e Can be used easily in refrigerant charging operation. e Detection ability is very low with vac- uum gauge in gauge manifold.
uum is detected in 10 minutes.uum gauge in gauge manifold.

e Leakage inspection of a refrigeration system needs a sensitivity greater than 20 g (0.71 oz)/year. e The actual amount of leak is estimated at 5 to 10 times the detected amount. e Insufficient cooling may be felt if leakage exceeds 150 to 200 g (5.29 to 7.05 oz).

Temperature gauge Use to check the air conditioner performance. An etched stem type thermometer may be used. A hygrometer must also be used because the air conditioner performance depends on the humidity.

Etched-stem type Wet and dry bulb ' thermometer hydrometer RHAS590B Scale Measure the weight of the refrigerant to determine how much the refrigerant is charged.

= /

Z Weight scale RHA591B

HA-24

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.