Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Service Tools (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Service Tools (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXService Tools (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Service Tools (Cont'd)

PREPARATION

Service Tools (Cont'd)

Installing the adapter valve Install the adapter valve to each of the high pressure and low pressure service valves so that air purging from the charging hose can be omitted. This also ensures that refrigerant leakage upon disconnection of the hose can be prevented. Connect to

1. Before connecting the adapter valve to the on-vehicle charging hose service valve, turn the adapter valve handle fully counter- Opens clockwise to retract the pin.

CAUTION: Check the packing for any sign of deterioration or cracks. If any On-vehicle service valve RHA585B abnormality is found, replace it with a new one.

2. Connect the charging hose to the adapter valve. Turning the handle clockwise will cause the on-vehicle service valve pin to be pushed open by the adapter valve pin, thus opening the refrigerant passage. Turning the handle counterclockwise will close the passage. Before removing the adapter valve from the on-vehicle service valve, be sure to fully turn the handle counterclockwise to shut off the refrigerant passage.

Vacuum pump The vacuum pump is used to purge air and moisture from the inside of the refrigeration system by evacuation, thereby ensur- ing proper functioning of the air conditioner system. Check the vacuum pump to see that the vacuum pump capacity is greater than —100.0 kPa (-750 mmHg, —29.53 inHg).

RHA587B Vacuum pump performance check procedure Valve

1. Connect the vacuum gauge to the system.

2. Run the vacuum pump, and check to see that the needle pointers of the gauge manifold and vacuum gauge move (0 to -760 mmHg, smoothly, indicating a similar value. 0 to -29.92 inHg)

3. After running the vacuum pump for two or three minutes, read the vacuum gauge. The measured value indicates the capacity of the vacuum pump.

Connecting nipple RHA588B Gas leak detector Gas sampling adapter

Detecting section

| The gas leak detector is used to check whether the refrigeration system is leaking. The detector is available in two types; halide Probe torch or electrical. The features of these gas leak detectors are Battery cap Power pilot lamp listed on the next page. rotation direction Handling instruction “Gas name plate Power/sensitivity selector switch -L.€.D. lever meter RHAS89B HA-23

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.