Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Differential Case - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Differential Case - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDifferential Case - Nissan 240SX 1991-1992 Workshop Manual

Differential Case

ASSEMBLY

Differential Case

Whenever side gears or pinion mate gears are replaced, selection of thrust washers should be carried out. Before selecting thrust washers, make sure all parts are clean and well lubricated with hypoid gear oil.

THRUST WASHER SELECTION

R200V ONLY Install the previously removed thrust washer on right side gear.

1. On left side gear, install a suitable thrust washer. Temporarily tighten differential cases using two screws. Position differential assembly so that right side gear is on the

upper side. Place two feeler gauges with thickness of 0.03 mm fd

@ on gauge

Feeler gauge

(0.0012 in) between right side gear and thrust washer as shown

0.03 (0.0012) (f=) ®

0.03 (0.0012) (2) 0.10 (0.0039) at left. (2) 0.10 (0.0039) Do not insert feeler gauge in oil groove portion of differential case.

3. Rotate right side gear with a suitable tool attached to splines. Side gear (R.H.) lf right side gear cannot be rotated, replace thrust washer used on left side gear with a thinner one.

4. Replace both 0.03 mm (0.0012 in) feeler gauges with 0.10 mm Unit: mm (in) (0.0039 in) gauges. At this point, make sure right side gear SPD863 does not rotate. If it does, replace thrust washer on left side gear with a thicker one so that right side gear does not rotate.

R200 ONLY Install side gears, pinion mate gears, thrust washers and thrust 1, block into differential case.

SPD552

2. Fit pinion mate shaft to differential case so that it meets lock pin holes.

SPD553

PD-25

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.