TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Electrical Components Inspection (Cont’d)
CRANK ANGLE SENSOR
1. Remove distributor assembly from engine. Disconnect ig- nition wires and center cable from distributor. (Crank angle sensor harness connector should remain connected.)
2. Turn ignition switch ‘ON’.
3. Rotate crank angle sensor shaft slowly by hand and check voltage between terminals @, @) and ground.
| Terminal | Voltage |
|---|---|
| (@ (180° signal) | |
| (@ (180° signal) @ (1° signal) | Voltage fluctuates between 5V and OV. |
Crank angle . Sensor
4. Rotate crank angle sensor shaft slowly by hand and check = Connector
voltage between terminals @ and ©) ground.
REFINES)
Measure with circuit tester set in 100 mV range, AC.
Tester pointer deflects: O.K. Tester pointer does not deflect: N.G. If N.G., replace crank angle sensor. After this inspection, malfunction code No. 11 might be dis- played though the crank angle sensor is functioning properly. In this case erase the stored memory. SEF749K
AIR FLOW METER
€ Gt 4 ri,
1. Fold back air flow meter harness connector rubber as shown in the figure if the harness connector is connected. \ s . Turn ignition switch ‘‘ON”. Start engine and warm it up sufficiently. Check voltage between terminal @ and ground.
| Conditions | Voltage V |
|---|---|
| Ignition switch ‘“‘ON’”’ (Engine stopped.) | Approximately 0.2 |
| Idle (Engine is warmed-up sufficiently.) | Approximately 1.0 - 1.4 |
SEF748K
5. If N.G., remove air flow meter from air duct. Check hot film Terminal a for damage or dust. Temperature compensation resistor
~~ Hot film
resistor
SEF593K
ENGINE TEMPERATURE SENSOR
1. Disconnect engine temperature sensor harness connector. Pal
2. Check resistance as shown in the figure.
| Temperature °C (°F) | Resistance kQ |
|---|---|
| 20 (68) | 2.1-2.9 |
| 50 (122) | 0.68 - 1.00 |
| 80 (176) | 0.30 - 0.33 |
SEF536 If N.G., replace engine temperature sensor.
EF & EC-183
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.