DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
DISCHARGING, EVACUATING, CHARGING AND CHECKING
DISCHARGING, EVACUATING, CHARGING AND CHECKING
Confirmation of Amount of Charged Refrigerant
The amount of refrigerant charged into the system can be
observed through the sight glass by watching the flow of the
refrigerant and by reading the high pressure and low pressure
manifold gauges under the following conditions: CONDITIONS e Doors: Close completely. Window glasses: e Close completely. Intake door position: e@ RECIRC Mode door position: e VENT Blower fan: e HI TEMP control: e@
Optional [Set so that intake air temperature is 30 to
35°C (86 to 95°F).] AIR CON switch: e ON Engine speed: e Approx. 1,500 rpm
WORK PROCEDURE
Engine speed: Approx. 1,500 rpm ! After warming up engine, adjust intake air temperature to 30 to 35°C (86 to 95°F). Wait until high pressure is stabilized at approx. 1,471 kPa (15 kg/cm?, 213 psi).*1 *1: Cover the entire condenser until the required pressure is indicated. Vv Check the sight glass of the refrigerant system.*2 Touch the high and low pressure tubes of the system to get an idea of the temperature. *2: Refer to sight glass inspection. v N.G. If white clouding or air bubbles are found: Check to see whether the refrigerant Vv is free of white clouding and bubbles. O.K. Vv Charge refrigerant until while clouding or bubbles disappear. Wait for some time to allow the refrigerant to sta- bilize after charging, then check the condition through the sight glass. 4 Charged amount of refrigerant is O.K. A
HA-36
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.