Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 40 (Cont'd)

is

by 4 eo

INSPECTION START

=> <= == =e , O.K. "

CHECK VACUUM SOURCE. TO

INSPECTION END

SWIRL CONTROL VALVE.

1) Start engine and warm it up sufficiently. 2) Stop engine

\\ Vacuum hose (a

3) After a few seconds, discon- nect vacuum hose to swirl to swirl control valve MEF712A

control valve and restart en-

gine. €:

4) Make sure that vacuum exists

under the following condi- tions. Engine speed is less than 2,400 rpm: Vacuum should exist. Engine speed is more than 2,400 rpm: Vacuum should not exist. MEF713A IB) 1 N.G.

O.K. | CHECK VACUUM HOSE AND

CHECK CONTROL FUNCTION.

"| SWIRL CONTROL VALVE.

1) Check voltage between E.C.U. terminal @5) and ground. 1) Check vacuum hose and swirl Voltage: control valve for clogging, Engine speed is less than cracks and proper connection. 2,400 rpm: Approximately 0V Engine speed is more than ——

A Improper connection

2,400 rpm: Battery voltage SEF816F N.G. v | N.G.

CHECK POWER SUPPLY.

, | Check the following. 1) Stop engine. e Harness connectors(9), 2) Disconnect S.C.V. control so- e@ 10A fuse lenoid valve harness connec- e Harness continuity between tor. fuse and S.C.V. control sole- 3) Turn ignition switch ““ON’’. noid valve 4) Check voltage between termi- lf N.G., repair harness or con- nal () and ground. nectors. Voltage: Battery voltage O.K.; MEF714A

4 e&) DISCONNECT e

|[_cANIT ea

al MEF715A

EF & EC-157

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.