ASSEMBLY (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ASSEMBLY (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
ASSEMBLY (Model R200)
ASSEMBLY (Model R200)
Differential Case
1. Install side gears, pinion mate gears, thrust washers and thrust block into differential case.
SPD552
2. Fit pinion mate shaft to differential case so that ‘it meets lock pin holes.
3. Adjust clearance between rear face of side gear and thrust washer by selecting side gear thrust washer. Refer to S.D.S. Clearance between side gear thrust washer and differential case:
0.10 - 0.20 mm (0.0039 - 0.0079 in)
SPD828
4. Install pinion mate shaft lock pin with a punch. Make sure lock pin is flush with case.
5. Apply oil to gear tooth surfaces and thrust surfaces and check that they turn properly.
SPD322
PD-25
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.