Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis — Mode II (Self-diagnostic results)

CAUTION: The mode selector on the E.C.U. must be returned to the fully counterclockwise position, except when switching the modes. DESCRIPTION In this mode, a malfunction code is indicated by the number of flashes from the RED L.E.D. or the CHECK ENGINE LIGHT as shown below: Example: Code No. 12 and Code No. 33

0.6

0.3

0.6

0.3° | oan oN j OFF y) = ( |g ——s-4 >T—_T* — >| > Unit: second

2.1

0.9

0.6

2.1

0.3 Code No. 12 Code No. 33 Long (0.6 second) blinking indicates the number of ten digits and short (0.3 second) blinking indicates the number of single digits. For example, the red L.E.D. flashes once for 0.6 seconds and then it flashes twice for 0.3 seconds. This indicates the number “49” and refers to a malfunction in the air flow meter. In this way, all the problems are classified by their code numbers. Display code table

0.9

Code No.Detected itemsaienaira
11*Crank angle sensor circuitX xX x
11* 12Heneék | Air flow meter circuit rature sensor circuitx Xx X
13HweeEngine temperature sensor circuit circuitX XX X
14HeneekVehicle speed sensor circuitX XX x
21*Ignition signal circuit .C.U.X xx x
31HenedkE.C.U.x xx —
32HenedkE.G.R. functionx X— X
32 33Henedk HeedE.G.R. fun Exhaust gas sensor circuitX XX X
34Detonation sensor circuit tX XX —
35HaneekExhaust gas temperature sensor circuitX X— X
43HenceThrottle sensor circuitX xXX —
43 45HeneekInjector leak y)xX X—
54Signal circuit from A/T control unit to E.C.U. (A/T only)X X
55No malfunction in the above circuitsX

X: Available —: Not available Heweek : Check engine light item *- Check items causing a malfunction of crank angle sensor circuit first, if both code No. 11 and 21 are displayed at the same time.

EF & EC-42

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.