ENGINE COOLING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ENGINE COOLING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
ENGINE COOLING SYSTEM
ENGINE COOLING SYSTEM
Water Pump (Cont'd)
CAUTION: When removing water pump assembly, be careful not to get coolant on drive belt. e Water pump cannot be disassembled and should be replaced as a unit. e After installing water pump, connect hose and clamp securely, then check for leaks using radiator cap tester.
REMOVAL
1. Drain coolant from cylinder block and radiator.
2. Remove fan coupling with fan.
3. Remove power steering pump drive belt, alternator drive belt and air compressor drive belt.
4. Remove water pump.
Vehicle front SMA402C INSPECTION
1. Check for badly rusted or corroded vanes and body assem- bly.
2. Check for rough operation due to excessive end play.
SLC738 INSTALLATION
1. Before installing water pump, remove all traces of liquid gasket from mating surface using a scraper. e Also remove traces of liquid gasket from mating surface of cylinder block.
Scraper SLC188A
2. Apply a continuous bead of liquid gasket to mating surface of water pump. @ Use genuine liquid gasket or equivalent.
SLC480A LC-9
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.