Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

SPEED SENSOR CIRCUIT CHECK

N.G.

CHECK INPUT SIGNAL.

| Check the following items. @ Speed sensor and ground 3 AP)oa circuit for speed sensor — Refer to section EL. @ Harness continuity between A/T control unit and speed Select ‘’E.C.U. sensor

INPUT SIGNALS”.

PTMGH 1 Tor ore FAIL [| @ Read out the value of ‘‘CAR SPEED 4 eye heen ge Ei) aeT Mk fier . SES.NTR Eke" h SENSOR 2” while PE SEH m, 4li driving. EMF SE

1. el @ Check the value chan 2 UL T Ls. 4ll a Fi Lode em es according to driving LEVER Su ti H speed.

|

Check voltage between | A/T control unit termi- nal @?) and ground SAT320C ; while driving at 2 to 3 km/h (1 to 2 MPH) for 1 m (3 ft) or more. Electric Voltage: Varies from speedometer OV to 5V Speed sensor L | | O.K.

FP ECOE TL

A/T control unit

N.G. | 4. Perform A/T control unit

Perform self-diagnosis again after

input/output signal inspection.

driving for a while.

At2-3km/h

2. If N.G., recheck A/T control

OK. (1-2 MPH) unit pin terminals for damage v

or connection of A/T control

INSPECTION END

unit harness connector.

Y/G

SAT967D

AT-46

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.