Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual

ON-VEHICLE SERVICE

ON-VEHICLE SERVICE

Checking Steering Wheel Turning Force (Cont'd)

Average value = (Max. value + Min. value)

Average rack sliding force:

yy v4 2 .

167 - 226 N (17 - 23 kg, 37 - 51 Ib)

If rack sliding force is not within specification, overhaul steering

6. 8 ] Maximum value £ _L_| gear assembly. a &£ AS] Bs Minimum value x [3] eo ii —11.5

11.5 Rack stroke

(-0,453) Neutral (9.453) —>

position Unit: mm (in) SST717A

Checking Hydraulic System

Before starting, check belt tension, driving pulley and tire pressure.

1. Set Tool. Open shut-off valve. Then bleed air. (See ‘‘Bleeding Hydraulic System’’.)

2. Run engine. $T27091000 (J26357) Make sure temperature of fluid in tank rises to 60 to 80°C (140 to 176°F).

WARNING: High- pressure Warm up engine with shut-off valve fully opened. If engine is Started with shut-off valve closed, oil pressure in oil pump will increase to relief pressure, resulting in an abnormal rise in oil temperature.

3. Check pressure with steering wheel fully turned to left and right positions with engine idling at 1,000 rpm.

CAUTION: Low-pressure => . Direction of oil flow hose Do not hold the steering wheel in a locked position for more than 15 seconds. Refer to S.D.S.

4. If oil pressure is below the standard pressure, slowly close shut-off valve and check pressure. @ When pressure reaches standard pressure, gear is damaged. @ When pressure remains below standard pressure, pump is SST834 damaged.

CAUTION: Do not close shut-off valve for more than 15 seconds.

5. If oil pressure is higher than standard pressure, check oil pump flow control valve.

6. After checking hydraulic system, remove Tool and add fluid as necessary, then completely bleed air out of system.

ST-7

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.