Gear Components (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Gear Components (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
Gear Components (Cont'd)
DISASSEMBLY
Gear Components (Cont'd)
5. Remove rear side components on mainshaft and counter gear.
a. Release staking on countershaft nut and mainshaft nut and loosen these nuts. Mainshaft nut: Left-hand thread
b. Pull out O.D. counter gear with bearing with suitable puller.
c. Draw out reverse counter gear and spacer.
d. Remove snap rings from reverse idler shaft and draw out reverse idler gear, thrust washers and reverse idler gear bearing.
e. Remove speedometer drive gear and steel ball.
Remove snap ring and pull out overdrive mainshaft bearing, mal then remove snap ring. Remove mainshaft nut. Remove steel roller and washer. TO Remove roller bearing and washer. Remove O.D. main gear, needle bearing and baulk ring (O.D.). AT Remove O.D. coupling sleeve, shifting inserts and shifting insert springs.
SMT040B |. Press out mainshaft and counter gear alternately. @ Make sure to alternate pressing of mainshaft and counter gear so as not to allow the front surface of one to contact the rear surface of the other.
SUT
SMT751A
6. Remove front side components on mainshaft.
a. Remove 1st gear washer and steel ball.
b. Remove ist main gear and 1st gear needle bearing.
SMT383A MT-13
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.