Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Control Valve Upper Body (Cont’d)

DISASSEMBLY

1. Remove valves at parallel pins. @ Do not use a magnetic hand.

a. Use a wire paper clip to push out parallel pins.

b. Remove parallel pins while pressing their corresponding plugs and sleeves. @ Remove plug slowly to prevent internal parts from jumping out.

c. Place mating surface of valve facedown, and remove internal parts. @ if a valve is hard to remove, place valve body facedown and lightly tap it with a soft hammer. @ Be careful not to drop or damage valves and sleeves.

SAT824A

2. Remove valves at retainer plates.

a. Pry out retainer plate with wire paper clip.

Retainer plate SAT825A AT-126

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.