ACCELERATOR CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ACCELERATOR CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
ACCELERATOR CONTROL SYSTEM
ACCELERATOR CONTROL SYSTEM
CAUTION: e@ When removing accelerator cable, make a mark to indicate lock nut’s initial position. e@ Check that throttle valve opens fully when accelerator pedal is fully depressed and that it returns to idle position when pedal is released. e@ Check accelerator control parts for improper contact with any adjacent parts. e@ When connecting accelerator cable, be careful not to twist or scratch its inner wire. e Refer to section EL for A.S.C.D. cable adjustment. e Refer to “ON-VEHICLE SERVICE” in section AT for Kickdown switch adjustment.
(3-4 (0.3 - 0.4, 2.2 - 2.9)
() 8 - 12 (0.8 - 1.2, 5.8 - 8.7)
Kickdown switch (A/T models only) —~ ae 2 (0.3 - 0.4, 2.2 - 2.9) _ 3-4
Accelerator pedal 0) : Nem (kg-m, ft-lb) SFE236A
Adjusting Accelerator Cable
Lock nut
Throttle drum (O}s8-11N-m
1. Loosen lock nut, and tighten adjusting nut until throttle (0.8 - 1.1 kg-m, drum starts to move.
5.8 - 8.0 feib)
2.
From that position turn back adjusting nut 1.5 to 2 turns, and
fasten it with lock nut.
Accelerator cable Adjusting nut
SFE249A FE-2
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.