Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

PROPELLER SHAFT - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › PROPELLER SHAFT - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXPROPELLER SHAFT - Nissan 240SX 1991-1992 Workshop Manual

PROPELLER SHAFT

PROPELLER SHAFT

3S63A-T Final drive Washer Propeller shaft

Apply a coat of multi-purpose lithium grease

2nd tube

containing molybdenum disulfide to the end

face of the center bearing and both sides of

the washer.

Lock nut &

245 - 294 Center bearing upper (25 - 30, 181 - 217) mounting bracket

Companion flange (C) 34 - 44 (3.5 - 4.5, 25 - 33) Center bearing assembly Install center bearing with “F” mark toward front of vehicle.

Propeller shaft 1st tube

Center bearing cushion

enting (0) 32 - 38 (3.3 - 3.9, 24 - 28) (0):

Nem (kg-m,

ftp) : Nem (kg-m, ft-l SPD105A bracket 3S63A-R Washer Final drive Apply a coat of multi-purpose lithium grease containing molybdenum disulfide to the end Propeller shaft 2nd tube face of the center bearing and both sides of the washer.

Lock nut ><)

C) 245 - 294 (25 - 30, 181 - 217) Center bearing upper mounting bracket

Rubber coupling (Do not disassemble.) (O} 34 - 44 (3.5 - 4.5, 25 - 33) Center bearing assembly Install center bearing with “F” mark toward front of vehicle.

Propeller shaft 1st tube Center bearing Center bearing cushion lower mounting

(OQ) : Nem (kg-m, ft-Ib)

bracket (©) 32 - 38 (3.3 - 3.9, 24 - 28) SPD106A

PD-5

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.