Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Basic Inspection (Cont'd)

®

| Vv

YW MONITOR WNO FAIL [_]

START SIGNAL

OFF

CHECK SWITCH INPUT SIGNAL.

N.G. 4) Repair or replace the

oo . . .

malfunctioning switch or

.

Select the following switches in

ON OFF

IDLE POSITION

AIR COND SIG

its circuit.

mode,

DATA MONITOR”

ON a) Start signal, b) Idle position, c) Air conditioner signal, [ RECORD d) Neutral (Parking) switch, and check the switches’ ON-OFF op- SEF723K eration. 7 OR a= (Fe) Remove E.C.U. from front floor AIC LS panel and check the above switches’ ON-OFF operation us- ing voltmeter at each E.C.U. ter- minal. Switch Condition Voltage (V) Start IGN i IGN 0 — Battery signal ON START] voltage Engine warmed up sufficiently SEF1501 Idle Idle position Battery voltage position — Depress -0V the accelera- tor pedal. A/C > A/C A/C OFF ON

NEUTRAL SW

7.0 - 10.0 signal (Engine > 0.5 - 0.7 running) Shift lever is “N” or “P”’ Neutral (Parking) | position > 0— 8.0 - 10.0 switch Except ‘’N’”’ and ‘‘P”’ O.K. 8 |

MSELF-DIAG RESULTSEE[_]

FE a |

FAILURE DETECTED

TIME

READ SELF-DIAGNOSTIC RESULTS.

Yes ,| Go to the relevant inspec-

ENGINE TEMP SENSOR

0O co

1. Perform ‘“SELF-DIAG

"| tion procedure.

RESULTS” mode.

2. Read out self-diagnostic re- sults.

3. Is a failure detected? OR

ERASE ||

PRINT _|

1. Set ‘‘Self-diagnostic results

SEF 151 mode” in Mode II. (Refer to S, page EF & EC-42.)

2. Count the number of RED L.E.D. or check engine light flashes and read out the codes.

3. Are the codes being output? No Vv Check engine light

INSPECTION END

RED L.E.D.

SEF621K

EF & EC-59

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.