ACCELERATOR CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ACCELERATOR CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
ACCELERATOR CONTROL SYSTEM
ACCELERATOR CONTROL SYSTEM
@ When removing accelerator cable, make a mark to indicate lock nut’s initial position. @ Check that throttle valve fully opens when accelerator pedal is fully depressed and that it returns to idle position when pedal is released. @ Adjust accelerator cable according to the following procedure. Tighten ‘“‘adjusting nut” until “throttle drum” starts to move. From that position turn back ‘‘adjusting nut’ 1.5 to 2 turns, and fasten it with a lock nut. @ Check accelerator control parts for improper contact with any adjacent parts. @ When connecting accelerator cable, be careful not to twist or scratch its inner wire.
Lock nut 0) 8-11 (0.8 -1.1,5.8 -8.0) Adjusting nut os - 11 (0.8 - 1.1,5.8 -8.0) A.S.C.D. actuator
AS co__/
Lock nut
Adjusting nut
Kinckdown switch 2-4 (0.3 - 0.4, 2.2 - 2.9)
Lock nut Wire end 8-12 (0.8 - 1.2, 58 -8.7) Adjusting nut Accelerator Accelerator wire bracket pedal
0.3-1mm I~ - () 8-11 (0.8 -1.1,5.8 - 8.0) (0.012 0.039) in Throttle drum
C) : N-m (kg-m, ft-lb)
SFEO12A
FE-2
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.