REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REAR AXLE — Drive Shaft - Nissan 240SX 1991-1992 Workshop Manual
REAR AXLE — Drive Shaft
REAR AXLE — Drive Shaft
Assembly (Cont'd)
7. Lock new larger boot band securely with a suitable tool, then lock new smaller boot band.
SFA472
WHEEL SIDE
Install new small boot band and boot on drive shaft.
1.
(le
Cover drive shaft serration with tape to prevent damage to
4
boot during installation.
( (0
SF A800
2. Install spider assembly securely, making sure marks are prop- erly aligned. Press-fit with spider assembly serration chamfer facing shaft.
3. Install new snap ring. | Xe Suitable tool
Chamfer SFA397 i
4. Pack drive shaft with specified amount of grease. r >| Specified amount of grease: 145 - 155 g (5.11 - 5.47 oz)
5. Install slide joint housing, then install new snap ring “A”.
6. Set boot so that it does not swell and deform when its dnd length is “L.”. Length “L.”: = 110.5 - 112.5 mm (4.35 - 4.43 in) Make sure that boot is properly installed on the drive shaft groove. SRA125A
7. Lock new larger and smaller boot bands securely with a suitable tool.
Boot band SFA395
RA-18
Parts & tools for this job For Nissan 240SX
- PARTRear wheel bearingSearch: Nissan 240SX rear wheel bearing
- TOOLBearing puller kitSearch: wheel bearing puller kit
- PARTCV boot kitSearch: Nissan 240SX cv boot kit
As an Amazon Associate we earn from qualifying purchases.