Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

WHEN SOLDERING BRUSH LEAD WIRE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › WHEN SOLDERING BRUSH LEAD WIRE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXWHEN SOLDERING BRUSH LEAD WIRE - Nissan 240SX 1991-1992 Workshop Manual

WHEN SOLDERING BRUSH LEAD WIRE

CHARGING SYSTEM — Alternator — Diode Check (Cont’d) SUB-DIODES {MITSUBISHI make] Attach ohmmeter’s probe to each end of diode to check for e continuity. Continuity is N.G. ... Replace diode assembly. e

SEL494H Assembly Carefully observe the following instructions. When soldering each stator coil lead wire to diode assem- e bly terminal, carry out the operation as fast as possible.

WHEN SOLDERING BRUSH LEAD WIRE

[MITSUBISHI make] [MITSUBISHI make] Wear Position brush so that its wear limit line protrudes 2 mm e limit fine (0.08 in) beyond end face of brush holder. oO] i : 2mm (0.08 in)

SEL386L

RING FITTING IN REAR BEARING

Quantity of protrusion: Fix ring into groove in rear bearing so that it is as close to Fix ring at the position e of minimum protrusion. the adjacent area as possible.

CAUTION: Do not reuse rear bearing after removal.

Rear bearing SEL633D

REAR COVER INSTALLATION

[MITSUBISHI make] (1) Before installing front cover with pulley and rotor with rear cover, push brush up with fingers and retain brush by inserting brush lift wire into brush lift hole from outside. (2) After installing front and rear sides of alternator, pull out | brush lift wire.

SEL766D | EL-28

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.