Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CLUTCH DISC AND CLUTCH COVER - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CLUTCH DISC AND CLUTCH COVER - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCLUTCH DISC AND CLUTCH COVER - Nissan 240SX 1991-1992 Workshop Manual

CLUTCH DISC AND CLUTCH COVER

CLUTCH DISC AND CLUTCH COVER

Flywheel Clutch disc @ Do not clean in solvent. @ When installing, be careful that grease applied to main drive shaft does not adhere to clutch disc.

Clutch cover securing bolt (0) 22 - 29 N-m (2.2 - 3.0 kg-m, 16 - 22 ft-lb)

Clutch cover ©: Apply lithium-based grease including molybdenum disulphide. SCL354

Clutch Cover and Flywheel

INSPECTION AND ADJUSTMENT

@ Set Tool and check height and unevenness of diaphragm spring. Diaphragm spring height “A”:

33.0 - 35.0 mm (1.299 - 1.378 in) @ Check thrust rings for wear or damage by shaking cover assembly and listening for chattering noise, or lightly ham- mering on rivets for a slightly cracked noise. Replace clutch cover assembly if necessary. @ Check pressure plate and clutch disc contact surface for slight burns or discoloration. Repair pressure plate with emery paper. @ Check pressure plate and clutch disc contact surface for deformation or damage. Replace if necessary.

A V4 tst2o050100( — ) | $T20050010( — ) SCL219 _ @ Adjust unevenness of diaphragm spring with Tool.

a. eee.

Uneven limit:

0.7 mm (0.028 in)

CL-11

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.