Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREMOVAL AND INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual

REMOVAL AND INSTALLATION

REMOVAL AND INSTALLATION

Removal — Propeller shaft Prope —Control housing Starter motor Speed sensor

Neutral switch harness connector

\; mounting bracket

harness “a |

.

ar i — O.D. switch Clutch operating

\ harness connector

cylinder —

Los Rell N

\ an ; / -,

Top switch harness connector Exhaust tube Reverse lamp switch— mounting bracket harness connector Gusset SMT796B Remove clutch operating cylinder from transmission. Disconnect speed sensor, O.D. switch top (4th) switch, reverse lamp switch and neutral switch harness connectors. Remove starter motor from transmission. Remove propeller shaft. — Refer to section PD. Insert plug into rear oil seal after removing propeller shaft. Be careful not to damage spline, sleeve yoke and rear oil seal when removing propeller shaft. Remove exhaust tube mounting bracket from transmission. Support manual transmission with a jack. Remove rear mounting bracket. Lower manual transmission as much as possible. Remove shift lever with control housing from transmission.

@ Remove gussets and transmission fixing bolts. @ Remove transmission from engine. @ Support manual transmission while removing it.

MT-6

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.