TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 10 — Engine Stalls when
a Turning F FUEL
CHECK FUEL LEVEL.
_
LN.G. 4) Fill fuel tank with fuel.
~— Check to see that there is enough fuel in tank. aan O.K. - E* v
PERFORM POWER BALANCE TEST.
No
__y! Go to Kj.
1. Perform “POWER BALANCE” in “ACTIVE TEST” mode.
SEF386! a
2. Is there any cylinder which
[] does not produce a momen-
@m active test m@
* *& * POWER BALANCE * * ®
tary engine speed drop? ==s=== MONITOR ===== OR
= 712rpm When disconnecting each injec-
CAS-RPM (REF)
AIR FLOW MTR
___1.02V
37% tor harness connector one ata time, is there any cylinder which Me 2 3
AAC VALVE
4) test
does not produce a momentary
Lea engine speed drop? Yes SEF729K Vv la No p| Check injector(s) and cir-
LL IL
CHECK INJECTOR.
DISCONNECT cuit(s).
1. Remove crank angle sensor from engine. (Crank angle sensor harness connector should remain connected.)
2. Disconnect ignition coil harness con- nector.
3. Turn ignition switch ON. (Do not start engine.)
4. When rotating crank angle sensor shaft, does each injector make an operating sound? Yes 4 v N.G.
Check ignition coil, power Vv
CHECK IGNITION SPARK.
1. Disconnect ignition wire from rocker transistor unit and cir- cuits. (See page EF & cover.
2. Connect a known good spark plug to EC-107.) the ignition wire.
3. Place end of spark plug against a suitable ground and crank engine.
4. Check for spark. SEF837K O.K. v (Go to ® on next page.) Ignition wire
Spark plug
SEF282G
EF & EC-72
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.