CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
CYLINDER BLOCK
CYLINDER BLOCK
Inspection (Cont'd)
a. When grinding crankshaft journal, confirm that “‘L”’ dimen- sion in fillet roll is more than the specified limit. “L”: 0.1 mm (0.004 in)
b. Refer to S.D.S. for grinding crankshaft and available service parts.
SEM964
8. If crankshaft is reused, measure main bearing clearance and select thickness of main bearing. If crankshaft is replaced with a new one, it is necessary to select thickness of main bearings as follows:
a. Grade number of each cylinder block main journal is punched on the respective cylinder block.
b. Grade number of each crankshaft main journal is punched Crank main on crankshaft. journal grade number
SEM272C suitable thickness according to
c. Select main bearing with the following table. Main bearing grade number:
| Main journal | ||||
|---|---|---|---|---|
| Crankshaft | grade number | 0 | 1 | 2 |
| journal grade | ||||
| number | 0 | 0 | 1 | 2 |
| 1 | 1 | 2 | 3 | |
| 2 | 2 | 3 | 4 |
For example: Main journal grade number: 1 Crankshaft journal grade number: 2 Main bearing grade number = 1+ 2 = 3
EM-43
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.