TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 3 — Unstable Idle (Cont'd)
oo} g Yes
CHECK FOR INTAKE AIR LEAK.
Discover air leak location Vv When pinching blow-by hose (lowering and repair. the blow-by air supply), does the en- gine speed rise? Cc 2 No | Vv No
CHECK IDLE ADJ. SCREW CLOGGING.
Check for A.A.C. valve Vv
1. Perform ““AAC VALVE ADJ”’ clogging or throttle valve SEF300G in “WORK SUPPORT” mode. clogging.
2. Can you set engine speed at
MAAC VALVE ADJ g [7]
650+ 50 rpm (A/T in ‘‘N”’ posi-
SET ENGINE RPM AT THE
tion) by turning idle adjusting
SPECIFIED VALUE UNDER
screw?
THE FOLLOWING CONDITION
OR
@ ENG WARMED UP
1. Disconnect A.A.C. valve har-
@ NO LOAD
ness connector.
2. Can you set engine speed at 650+ 50 rpm (A/T in ‘‘N”’ posi- START tion) by turning idle adjusting SEF726K screw? Yes 10 v N.G. Check pistons, piston
CHECK COMPRESSION PRESSURE.
[> | e Check compression pressure. rings, valves, valve seats Standard: kPa (kg/cm’, psi)/300 rpm and cylinder head gas- kets. 1,236 (12.6, 179) Minimum: kPa (kg/cm?, psi)/300 rpm 1,040 (10.6, 151) Difference between each cylinder: kPa (kg/cm’,psi)/300 rpm SEF601K 98 (1.0, 14) S| O.K. oo v N.G.
CHECK E.C.U. HARNESS CONNECTOR.
,| Repair or replace. | Check the E.C.U. pin terminals for dam- COMPRESSION age or poor connection of E.C.U. har- ness connector. PRESSURE O.K. v
TRY A KNOWN GOOD E.C.U."
OK. SEF309G
Vv
INSPECTION END
*: E.C.U. may be the cause of a problem, but this is rarely the case.
EF & EC-64
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.