@ Less than specified value ... Replace. - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › @ Less than specified value ... Replace. - Nissan 240SX 1991-1992 Workshop Manual
@ Less than specified value ... Replace.
STARTING SYSTEM — Starter — Armature Check (Cont’d) Check diameter of commutator.
4. Commutator minimum diameter: Refer to S.D.S.
@ Less than specified value ... Replace.
om Vernier caliper
Commutator SEL418A
Check depth of insulating mold from commutator surface.
5. Undercut procedures
@ Less than 0.2 mm (0.008 in) ... Undercut to 0.5 to 0.8 mm
(0.020 to 0.031 in) ——
0.5 - 0.8 mm (0.020 - 0.031 in) Round
Correct
File
Commutator Segment Mold
Incorrect EE021 Assembly Apply high-temperature grease to lubricate the bearing, gears and frictional surface when assembling the starter.
PINION PROTRUSION LENGTH ADJUSTMENT
Pinion stopper Switch With pinion driven out by magnetic switch, push pinion back to >So—————f$ remove slack and measure clearance ‘“Q’’ between the front My edge of the pinion and the pinion stopper. , Clearance “Q”: T > | Battery Refer to S.D.S. T SEL299E Clearance ‘’2”’
EL-20
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.