Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CHARGING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CHARGING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCHARGING SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

CHARGING SYSTEM

CHARGING SYSTEM

Trouble-shooting Before conducting an alternator test, make sure that the battery is fully charged. A 30-volt voltmeter and suitable test probes are necessary for the test. The alternator can be checked easily by referring to the Inspection Table.

Before starting trouble-shooting, inspect the fusiblé link.

WITH IC REGULATOR

With alternator side L terminal grounded, internal short occurs Burned-out A) when + diode is short-circuited. bulb. Replace and Proceed Ignition Light “OFF” Disconnect Light “OFF 'J—— —~—-— - 7 7 rr rT to “A”.

switch “ON

Ly and ev ‘s.

-*See 4) for grounding F terminal.

and groun

Light “ON”

L lead wire.

Light “ON”

Connect con-

Light ““ON"’) — pamaaed IC-RG.

T (HITACHI nector (S, L) P : | make) and ground F | terminal

Light “OF F”)— {Damaged Ac.G.|

Engine idling to

|

' (MITSUBISHI

Dim light make) Damaged !C-RG Light flickers 9 or A.C.G. Bright light

Light “ON”

Check or replace — Engine idling

Light “ON” )— — — | Damaged Ac.G.|

drive belt. 'g

Engine speed:

Light “ON” )——--—-—--—-—-

——-—— --

— ~{Damaged Ac.G]|

1,500 rpm Lighting

switch “ON”

Light “OFF”

Engine speed:

More than 15.5V)— Damaged IC-RG.

1,500 rpm Replace. (Measure B terminal volt- 13 to 15Ve—— --| 0.k. | 1) Use fully charged battery. age.) 2) Light : Charge warning light Make sure connector A.C.G. : Alternator parts except IC regulator (S, L) is connected IC-RG : IC regulator correctly. O.K. : IC alternator is in good condition. 3) When reaching ‘‘Damaged A.C.G.”, remove alternator from vehicle and disassemble, inspect and correct or replace faulty parts. 4) “Method of grounding F terminal (HITACHI make only) Gasoline engine model Contact tip of wire with brush and attach wire to alternator body.

Brush lift wire

SEL766D

Terminals “’S”, “’L’”’, “‘B’ and “E” are marked on

5) rear cover of alternator. EL-23

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.