ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
ENGINE MAINTENANCE
ENGINE MAINTENANCE
Changing Fuel Filter (Cont'd)
(@)
1. Remove fuse for fuel pump.
2. Start engine.
3. After engine stalls, crank engine two or three times to make sure that fuel pressure is released. Fuel pump
4. Turn ignition switch off and install fuse for fuel fuse (10A) pump.
5. Loosen fuel hose clamps.
6. Replace fuel filter. e Be careful not to spill fuel over engine compartment. Place a shop towel to absorb fuel. e Use a high-pressure type fuel filter. Do not use a synthetic resinous fuel filter. @ When tightening fuel hose clamps, refer to “Checking Fuel Lines”’.
Changing Air Cleaner Filter
The viscous paper type filter does not need cleaning between renewals.
SMA008C
Changing Engine Oil
Filler cap
WARNING: Be careful not to burn yourself, as the engine oil is hot.
1. Warm up engine, and check for oil leakage from engine components.
2. Remove drain plug and oil filler cap.
3. Drain oil and refill with new engine oil. Oil grade: AP! SG Oil filter Viscosity: See ‘RECOMMENDED LUBRICANTS AND FLUIDS” in MA Oil drain plug SMA363C section. Refill oil capacity (Approximately): Unit: liter (US qt, Imp qt) With oil filter change
3.8 (4, 3-3/8) Without oil filter change
3.5 (3-3/4, 3-1/8)
MA-11
Parts & tools for this job For Nissan 240SX
- PARTEngine gasket setSearch: Nissan 240SX engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.