Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ASSEMBLY (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ASSEMBLY (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXASSEMBLY (Model R200V) - Nissan 240SX 1991-1992 Workshop Manual

ASSEMBLY (Model R200V)

ASSEMBLY (Model R200V)

Differential Carrier (Cont'd)

14. Check runout of ring gear with a dial indicator. Runout limit:

0.05 mm (0.0020 in)

SPD524

15. Measure ring gear to drive pinion backlash with a dial indicator. Ring gear to drive pinion backlash:

0.10 - 0.15 mm (0.0039 - 0.0059 in) e If backlash is too small, decrease thickness of left shim and increase thickness of right shim by the same amount. If backlash is too great, reverse the above procedure. Never change the total amount of shims as it will change the bearing preload. SPD513

16. Check total preload with Tool. Ss When checking preload, turn drive pinion in both directions several times to seat bearing rollers correctly. Total preload: Value more than 0.29 N-m (3.0 kg-cm, 2.6 in-Ib) (4 added on measured value of drive pinion preload e lf preload is too great, remove the same amount of shim from each side. NF e lf preload is too small, add the same amount of shim to each side.

oe Tool

—_—_— V ———a SPDO56A Never add or remove a different number of shims for each side as it will change ring gear to drive pinion backlash.

17. Recheck ring gear to drive pinion backlash because in- crease or decrease in thickness of shims will cause change of ring gear to pinion backlash. e lf backlash varies excessively in different places, foreign matter may be caught between the ring gear and the differential case. elf the backlash varies greatly when the ring gear runout is within a specified range, replace the hypoid gear set or differential case.

18. Check tooth contact. Refer to ADJUSTMENT.

PD-47

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.