DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
‹ Prev DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop ManualNext › SERVICE PROCEDURES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
DISCHARGING, EVACUATING, CHARGING AND CHECKING
DISCHARGING, EVACUATING, CHARGING AND CHECKING
Confirmation of Amount of Charged Refrigerant (Cont'd)
| Amount of | Overcharged, or | |||
|---|---|---|---|---|
| of charge Check item | Appropriate | Refrigerant is insufficient | Almost no refrigerant | Overcharged, or air in system |
| Temperature of high and | High pressure side is hot | High pressure side is | No difference is felt | High pressure side is very |
| low pressure pipes | while low pressure side is | warm and low pressure | between high and low | hot. |
| cold. | side is somewhat cold. | presser sides. | ||
| Flow of refrigerant viewed | Mostly transparent. | Bubbles are always flow- | Nothing Is visible. | If overcharged, no bub- |
| through sight glass | Occasionally some bub- | ing. Refrigerant is cloudy. | bles are seen. If there is | |
| bles are seen when | air in the system, large | |||
| engine rpm is increased | bubbles are seen. | |||
| or decreased. | ||||
| Pressure | Normal! high pressure: | Both high and low pres- | High pressure value is | Both high and low pres- |
| 1,373 - 1,765 kPa (14 - 18 kg/cm?, | sure values are insuffi- | very small. | sure values are exces- | |
| (14 - 18 kg/cm?, | cient. | sive. | ||
| 199 - 256 psi) | ||||
| Normal low pressure: | ||||
| 147 - 294 kPa | ||||
| (1.5 - 3 kg/cm?, | ||||
| 21 - 43 psi) | ||||
| Action to take | Bubbles may be gener- | Add refrigerant after | Check the refrigerant sys- | Stop the compressor and |
| ated when the liquid tank | checking for leaks. | tem. | extract excessive refriger- | |
| strainer is clogged, or | ant. If air is found, per- | |||
| when the expansion valve | form evacuation, then | |||
| is opened excessively. | charge the specified | |||
| amount of refrigerant. |
CAUTION: The condition of bubbles seen through the sight glass as well as the intake and discharge pressures are influenced by the ambient temperature, wind velocity, weather, and by the air temperature in front of the condenser, etc.
HA-35
‹ Prev DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop ManualNext › SERVICE PROCEDURES - Nissan 240SX 1991-1992 Workshop Manual
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.