Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 13

HB wo “Pi OFF SYMPTOM: A/T does not hold lock-up condition for

more than 30 seconds.

Self-diagnosis start 1 | — - -- Light Does self-diagnosis show damage Yes | Check engine revolution signal to engine revolution signal circuit circuit. after cruise test? — Refer to ‘Self-diagnosis’’. - Shade -4 No SAT763B ;

1. Remove oil pan. N.G.

1. Remove control valve assem-~

2. Check A/T fluid condition. bly. — Refer to ‘“‘ON-VEHI- O.K.

CLE SERVICE”.

2. Check the following items. ® Lock-up control valve || @ Pilot valve OK. e Pilot filter

3. Disassemble A/T. O.K.

4. Check torque converter and < oil pump assembly. SAT171B ‘ N.G. Check again. »|

1. Perform A/T control unit input/output signal inspection. O.K.

2. If N.G., recheck A/T control y unit pin terminals for damage

INSPECTION END

or connection of A/T control unit harness connector.

Diagnostic Procedure 14

1 OFF

SYMPTOM: Lock-up is not released when accelerator

Self-diagnosis | pedal is released. startpo Light

Does “E.C.U. INPUT

Yes

Check idle switch circuit. — Refer

SIGNALS” show damage to “Self-diagnosis’”. to idle switch circuit? 4-—- Shade SAT157C |» OR 1 |

Accelerator pedal

®) Does self-diagnosis show

damage to idle switch circuit? | No Vv NG Release “=! 1. Perform A/T control unit Check again. input/output signal inspection. yo*

2. If N.G., recheck A/T control 4s unit pin terminals for damage

INSPECTION END

or connection of A/T control SAT806A . unit harness connector. AT-71

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.