SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS SYSTEM — Trouble Diagnoses
SUPER HICAS SYSTEM — Trouble Diagnoses
Diagnostic Procedure 2 (Cont'd)
SYMPTOM (B):
Warning lamp comes on when ignition switch is turned ON; however, it does not go out after engine start. [fy sevect o1aG Move [_]]
SELF-DIAG RESULTS
DATA MONITOR
START
| ACTIVE TEST
ECU PART NUMBER
L__ L ELL Vv Check in self-diagnosis mode. O.K. || No engine rpm signal is Refer to page ST-48. entered.
Warning lamp
N.G. ¥ remains ON ®
Repair malfunctioning Vv part detected by self-di- agnosis. Refer to Diagnostic Pro- cedures 5 to 11. ¥ ® LB) Vv SST460B Check rear wheel action. No __.| No power is supplied to Left and right rear wheels are turned in control unit. response to rotation of steering wheel. Refer to page ST-43. Yes Vv Insufficient oil quantity.
» |a Vv
Replace fluid level sensor (on reservoir |
{A) tank) if warning lamp remains on dur- ing engine operation.
ST-52
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.