PARKING BRAKE CONTROL - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › PARKING BRAKE CONTROL - Nissan 240SX 1991-1992 Workshop Manual
PARKING BRAKE CONTROL
PARKING BRAKE CONTROL
Adjustment Box wrench
1. Ensure that parking brake releases when control lever is Adjusting pulled down completely. If control lever does not release
parking brake, proceed as follows:
nut @ Pull control lever up by 4 or 5 notches. \ @ Insert a box wrench into opening in control lever and loosen self-lock adjusting nut to slacken cables. Completely push control lever down.
2. Forcefully depress brake pedal about five times (so that caliper is automatically set in position.). SBRA490A
3. Pull lever up by 4 or 5 notches.
4. Turn adjusting nut as shown in figure at left and adjust lever stroke to specified value.
5. Completely push control lever down and ensure that: @ Parking brake is released completely. @ Rear brakes are free from dragging.
6. Pull control lever with specified amount of force. Check lever stroke and ensure smooth operation. Number of notches: Center lever type 6 - 8 196 N (20 kg, 44 Ib) NN
SBR491A
7. Bend parking brake warning lamp switch plate so that brake warning light comes on when ratchet at parking brake lever is pulled ““A’’ notches and goes out when fully released. Number of ‘‘A”’ notches: 1
Parking brake warning lamp switch SBR493A plate
BR-24
Parts & tools for this job For Nissan 240SX
- PARTBrake padsSearch: Nissan 240SX brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.