Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

POWER STEERING OIL PUMP - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › POWER STEERING OIL PUMP - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXPOWER STEERING OIL PUMP - Nissan 240SX 1991-1992 Workshop Manual

POWER STEERING OIL PUMP

POWER STEERING OIL PUMP

Assembly Assemble oil pump, noting the following instructions. @ Make sure O-rings and oil seal are properly installed. @ Always install new O-rings and oil seal. Be careful of oil seal direction. @ Cam ring, rotor and vanes must be replaced as a set if necessary. @ Coat each part with A.T.F. when assembling.

SST038A Rear cover side Front housing side @ Pay attention to the direction of rotor. Punchmark

SST289A @ When assembling vanes to rotor, rounded surfaces of vanes must face cam ring side.

Flat portion

Round portion SST843A

Insert pin @ into pin groove ( of front housing and front side

@

plate. Then install cam ring @) as shown at left.

Cam ring

SST497A ST-28

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.