Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

Differential Case (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Differential Case (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDifferential Case (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual

Differential Case (Cont'd)

ASSEMBLY

Differential Case (Cont'd)

3. Adjust clearance between rear face of side gear and thrust washer by selecting side gear thrust washer. Refer to S.D.S. Clearance between side gear thrust washer and differential case:

0.10 - 0.20 mm (0.0039 - 0.0079 in)

SPD828 ASSEMBLY

1. Install differential case A and B. —R200V ONLY—

SPD862

1. Install pinion mate shaft lock pin with a punch. —R200 ONLY— Make sure lock pin is flush with case.

SPDO30

2. Place differential case on ring gear.

3. Apply locking sealant to ring gear bolts, and install them. Tighten bolts in a criss-cross fashion, lightly tapping bolt head with a hammer.

SPD554

4. Press-fit side bearing inner cones on differential case with Tool. Tool number: (A) KV38100300 (J25523) $T33061000 (J8107-2)

PD353 PD-26

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.