Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 24 (Cont’d)

INSPECTION START

Vv N.G.

Check the following. e@ Harness connectors(fé), 1) Disconnect air flow meter harness connector. 2) Turn ignition switch “ON”. e Harness continuity @ 3) Check voltage between terminal © between air flow meter and E.C.C.S. relay and ground. If N.G., repair harness or Voltage: Battery voltage connectors. O.K. LB) ~ DISCONNECT FP DISCONNECT

CHECK POWER SUPPLY.

W4e> Ae

rf ee Vv Ei N.G.

(Ccvunr— fof CONNECTOR ]| dalb] c]dp

Repair harness or con- 1) Turn ignition switch ‘OFF’. nectors. 17 | 2) Disconnect E.C.U. harness connec- tor. 3) Check harness continuity between [Q] (&)

CHECK GROUND CIRCUIT.

terminal © and E.C.U. terminal @.

Continuity should exist. ° y, ~ MEF686A O.K. ¥ N.G. ,| Repair harness or con-

CHECK INPUT SIGNAL CIRCUIT.

WIMONITOR NO FAIL [ ]

~y\, 1) Reconnect air flow meter har- nectors.

AIR FLOW MTR

0.94V ness connector and E.C.U. harness connector. 2) Start engine and warm it up sufficiently. 3) Read air flow meter signal in “DATA MONITOR” mode with _| a RECORD CONSULT. Voltage: 0.8 - 1.2V SEF732K (At idle) OR

=a 7g DISCONNECT

Pn af) DISCONNECT

1) Check harness continuity Me €&) between terminal @ and

ra[blela © [[_e/unit [ol CONNECTOR J]

E.C.U. terminal (6). Continuity should exist. 16 O.K. Vv a2) N.G.— @)

CHECK COMPONENT

Replace air flow meter. ~ (Air flow meter). Refer to “Electrical Components MEF687A Inspection’”’. (See page EF & EC-163.) O.K. y Check E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.

EF & EC-100

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.