ON-VEHICLE INSPECTION - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ON-VEHICLE INSPECTION - Nissan 240SX 1991-1992 Workshop Manual
ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
Checking Steering Wheel Play
1. With wheels in a straight-ahead position, check steering whee play. | Steering wheel play: 35 mm (1.38 in) or less
2. If it is not within specification, check steering gear assembly when front suspension and axle, steering gear assembly and steering column are mounted correctly.
SST103B
Checking Neutral Position on Steering Wheel
O.K. N.G. Pre-checking @ Make sure that wheel alignment is correct. Wheel alignment: /
Refer to section FA for S.D.S.
\ Sy @ Verify that the steering gear is centered before removing the steering wheel. XQ SY Checking —
@ Check that the steering wheel is in the neutral position when
driving straight ahead. SST104B @ If it is not in the neutral position, remove the steering wheel and reinstall it correctly. @ lf the neutral position is between two serrated teeth, loosen tie-rod lock nut and move tie-rod in the opposite direction by the same amount on both left and right sides to compensate for error in the neutral position.
Front Wheel Turning Angle
@ Rotate steering wheel all the way right and left: measure turning angle. Turning angle of full turns: Refer to section FA for S.D.S.
SMA127 @ If it is not within specification, check rack stroke. Measured length “L”’: Refer to S.D.S.
SSTO86B
ST-5
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.