TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 16 — Engine Stalls when
the Electrical Load is Heavy
N.G. i
CHECK BATTERY AND ALTERNATOR.
Repair or replace. | Check battery and alternator condition. (Refer to EL section.) O.K. Vv No Go to fj.
PERFORM POWER BALANCE TEST.
Vv SEF3891
1. Perform ‘“‘“POWER BALANCE” in “ACTIVE TEST” mode.
2. Is there any cylinder which
M Active test gw
L] does not produce a momen-
* * *& POWER BALANCE * * *
tary engine speed drop?
MONITOR ==
; ts 4 OR
712rpm When disconnecting each injec-
CAS+RPM (REF)
AIR FLOW MTR
1.02V
37% tor harness connector one at a time, is there any cylinder which | IRB does not produce a momentary engine speed drop? Yes SEF729K ; Vv NWA No
AAC VALVE
CHECK INJECTOR.
Check injector(s) and cir- Vv OSCONNECT cuit(s).
1. Remove distributor assembly from engine. (Crank angle sensor harness connector should remain connected.)
2. Disconnect ignition coil harness con- nector. Cia? AKSI
3. Turn ignition switch ON. (Do not start engine.) Fuel injector connector /
4. When rotating crank angle sensor aa es shaft, does each injector make an SEF738K operating sound? Yes v N.G.
p| Check ignition coil, power
CHECK IGNITION SPARK.
1. Disconnect ignition wire from rocker transistor unit and cir- cuits. (See page EF & cover.
2. Connect a known good spark plug to EC-107.) the ignition wire.
3. Place end of spark plug against a suitable ground and crank engine.
4. Check for spark. SEF837K 1O.K. Vv (Go to @ on next page.) Ignition wire
4 Spark plug - g r i SEF282G
EF & EC-86
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.