SUPER HICAS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS
SUPER HICAS
Rear Wheel Alignment
TOE-IN Draw a base line across the tread.
1.
After lowering rear of vehicle, move it up and down to eliminate
friction.
SMA123
2. Measure toe-in. Lines parallel to Measure distance “A” and ‘‘B” at the same height as hub center. center line of body Toe-in: A-B
0.5 - 4.5 mm (0.020 - 0.177 in) 24 (Total toe-in angle) 3/ - 25!
Front! ¢
Toe-in=A —B SFA234A 6 Total toe-in angle = 26
3. Adjust toe-in by varying length of power cylinder lower links. Woae out (1) Loosen lock nuts. (2) Adjust toe-in by turning lower links forward or backward. Z=—
XN] 8p); "/
LS SD
Yy i} o SRA259A Make sure both lower links are the same length. Standard length “L”’: 185.5 mm (7.30 in) (3) Tighten lock nuts to the specified torque. (): 37 - 46 Nem aaa == 6) (3.8 - 4.7 kg-m, 27 - 34 ft-lb) @ Refer to CHECK AND ADJUSTMENT for other procedures.
SRA260A
RA-23
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.