Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 10 — Engine Stalls when

Turning oO F FUEL N.G. p| Fill fuel tank with fuel.

CHECK FUEL LEVEL.

~ Check to see that there is enough fuel in tank. O.K. - A v No Go to fy.

PERFORM POWER BALANCE TEST.

1. Perform ‘““POWER BALANCE” SEF3861 in “ACTIVE TEST” mode. Cm

2. Is there any cylinder which

m active test gw

C] does not produce a momen-

* & & POWER BALANCE ¥ ¥ ¥

tary engine speed drop? OR

CAS+RPM (REF)

712rpm “ap When disconnecting each injec-

1.02V

AIR FLOW MTR

Wed

tor harness connector one ata

37%

AAC VALVE

= . time, is there any cylinder which |__| AER does not produce a momentary TEST L_ I engine speed drop? ILL START Yes SEF729K v No p| Check injector(s) and cir-

CHECK INJECTOR.

cuit(s).

1. Remove crank angle sensor from engine. (Crank angle sensor harness connector should remain connected.)

2. Disconnect ignition coil harness con- nector.

3. Turn ignition switch ON. (Do not start engine.) Fuel injector connector /

4. When rotating crank angle sensor PA // shaft, does each injector make an SEF738K operating sound? Yes 4 ) N.G. p| Check ignition coil, power

CHECK IGNITION SPARK.

transistor unit and cir-

1. Disconnect ignition wire from rocker cuits. (See page EF & cover. EC-114.)

2. Connect a known good spark plug to the ignition wire.

3. Place end of spark plug against a suitable ground and crank engine.

4. Check for spark. SEF837K lO.K. v (Go to @ on next page.) Ignition wire

4 a Spark plug gd i . SEF282G

EF & EC-73

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.