Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

“== Lock nut - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › “== Lock nut - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEX“== Lock nut - Nissan 240SX 1991-1992 Workshop Manual

“== Lock nut

SUPER HICAS SYSTEM — Repair of Component Parts

HICAS Solenoid and Fail-safe Valve e Do not loosen lock nut which secures solenoid since HICAS solenoid and fail-safe valves are of types that should not be disassembled. e If any part is found to be malfunctioning, always replace as a valve assembly.

“== Lock nut

\ HICAS solenoid SST721B

Lock nut Fail-safe valve SST722B e@ Whenever tubes are disconnected from fail-safe valve KV32101100 check tube seat for scratches or damage. A scratched or cracked tube seat may cause oil leakage. Replace it using pin punch.

SST397B Steering Angle Sensor e Ensure that steering angle sensor bolts are secure and tight. e If any part of steering angle sensor is malfunctioning, replace steering angle sensor assembly.

a % SST723B Steering Wheel

CHECKING NEUTRAL POSITION

@ Check that steering wheel is in neutral position when driv- ing straight ahead at a speed of at least 70 km/h (43 MPH). e if it is not in neutral position, remove steering wheel and ~— -_ reinstall it correctly. e If neutral position is between two serrated teeth, loosen tie-rod lock nut and move tie-rod in opposite direction by the same amount on both left and right sides to compensate for error in neutral position. SST104B ST-39

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.